CHAIN DRIVES IN LOW TORQUE DRIVES AND REDUCING PULSATIONS
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
projectsofme
Active In SP
**

Posts: 1,124
Joined: Jun 2010
#1
02-10-2010, 09:17 AM



.ppt   INTRODUCTION 2 CHAIN DRIVES.ppt (Size: 2.16 MB / Downloads: 124)
CHAIN DRIVES IN LOW TORQUE DRIVES AND REDUCING PULSATIONS

INTRODUCTION TO DRIVES

Mechanical components used for power transmission. It may be belt, chain or gear depending on engine design parameters like - Distance between crankshaft and camshaft, engine maximum speed, engine-torque and engine construction cost. - Power transmission is done from one shaft to another shaft which may or may not rotate at same speed.


CHAIN DRIVES (catia aided)
The chain are mostly used to transmit motion and power from one shaft to another , when the distance between the centers of the shafts is short .The wheels have project and implimentationing teeth and fit into the corresponding recess ,in the links of the chain

Reasons for chain drive preference –
Positive drive having no slip.
Takes less space than a belt or rope drive.
No initial tension required to set up.
Higher transmission efficiency. (98%)
Additional Operating Conditions
The chain operates in an indoor environment of −10°C to 60°C, and there is no abrasive dust.
no effects from corrosive gas or high humidity.
The two driving shafts are parallel with each other and adjusted properly.
Lubrication is applied.
The transmission is subject to only small fluctuations in load.



Important Note..!

If you are not satisfied with above reply ,..Please

ASK HERE

So that we will collect data for you and will made reply to the request....OR try below "QUICK REPLY" box to add a reply to this page

Possibly Related Threads...
Thread Author Replies Views Last Post
  toyota avanza timing chain marks jaseelati 0 248 30-12-2014, 02:56 PM
Last Post: jaseelati
  toyota avanza timing chain marks jaseelati 0 234 27-12-2014, 03:59 PM
Last Post: jaseelati
  toyota avanza timing chain marks jaseelati 0 191 27-12-2014, 03:52 PM
Last Post: jaseelati
  Low Speed Wind Turbines seminar ideas 2 4,247 26-07-2013, 10:15 AM
Last Post: study tips
  Design of a low-cost five-finger anthropomorphic robotic arm with nine degrees study tips 0 373 11-04-2013, 03:28 PM
Last Post: study tips
  Torque Measurement With Compliant Mechanisms study tips 0 375 10-04-2013, 03:39 PM
Last Post: study tips
  Use of Vegetable Oil Lubricant in a Low Heat Rejection Engine to Reduce Particulate project girl 0 361 05-02-2013, 11:21 AM
Last Post: project girl
  ELECTRIC DRIVES REPORT project girl 0 377 16-01-2013, 02:33 PM
Last Post: project girl
  Fabrication of Forced Induction System for IC engines at Low speeds seminar tips 0 342 03-01-2013, 10:28 AM
Last Post: seminar tips
  Biodiesel engine performance and emissions in low temperature combustion seminar tips 0 329 21-12-2012, 03:18 PM
Last Post: seminar tips