Carrier Based PWM Algorithm for Indirect Matrix Converters
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
project report helper
Active In SP
**

Posts: 2,270
Joined: Sep 2010
#1
08-10-2010, 10:40 AM






Carrier Based PWM Algorithm for
Indirect Matrix Converters


Bingsen Wang Giri Venkataramanan
Department of Electrical and Computer Engineering
University of Wisconsin-Madison
1415 Engineering Drive
Madison, WI 53706 USA


Abstract— In this paper, the indirect matrix converter is
systematically studied with the single-pole-multiple-pole
representation. A carrier based PWM algorithm is developed
in two steps. First, the continuous modulation functions for all
the throws are derived based on the desired sinusoidal input
currents. Then the switching functions are derived from the
modulation functions with focus on the zero current
commutation. The proposed PWM algorithm is verified by
numerical simulation and hardware experimentation on a
laboratory prototype matrix converter.
I. INTRODUCTION
Various attractive features of the matrix converter, such as
a potential for high power density through elimination of
bulky passive components, high quality input and output
current/voltage waveforms, are leading to continuous
research efforts to enable their adoption widely [1-6]. While
the matrix converter was first studied as a class of frequency
changers realized using controlled switches by Gyugyi [7],
significant progress in high frequency synthesis was made by
Venturini in 1980 [8-10], with voltage transfer ratio limited
to one half. An improved modulation strategy with a voltage
transfer ratio of 0.866 was published in 1989 [11, 12]. In
addition to Venturini’s modulation methods, indirect
modulation methods based on a fictitious dc link concept
[13-18] and space vector techniques have been developed
further [17, 19-23]. Irrespective of the modulation methods
used, robust commutation is critical, as has been extensively
investigated and examined [24-30]. As an alternative to the
standard 9-switch topology, the rectifier-inverter-without-dclink
structure and its variations have been carefully examined
[16, 31-37], leading to a simple and robust commutation on
the basis of its topological properties [34].
A space vector modulation scheme for the indirect matrix
converter (IMC) was developed with focus on the desired
output voltage in [34]. In this paper, a carrier based PWM
algorithm is proposed and derived based on the desired
sinusoidal input currents and output voltages. The derivation
proceeds with the calculation of modulation functions
followed by the generation of switching functions. Comparedto the space vector modulation scheme, the proposed carrier
based PWM algorithm demands less computational
complexity, while retaining the features of simple and robust
commutation. Thus, resources of the digital signal processor
commonly employed in the practical realization will be
available to assume complex computational tasks for the
controller rather than the modulator. Furthermore, with more
increasingly available field programmable gate array
(FPGA), the firmware implementation of carrier based PWM
algorithm may feature the reliability of hardware and the
flexibility of software.
The paper is organized as follows: In Section II the IMC is
represented using single-pole-multiple-throw (SPMT)
switches. The modulation functions are derived in Section III
followed by switching functions presented in Section IV. The
numerical simulation and the experimental results are
presented in Section V and Section VI, respectively. A
summary of the paper is presented in the concluding section.






ieeexplore.ieeeiel5/11209/36090/01712191.pdf
Reply

Important Note..!

If you are not satisfied with above reply ,..Please

ASK HERE

So that we will collect data for you and will made reply to the request....OR try below "QUICK REPLY" box to add a reply to this page

Quick Reply
Message
Type your reply to this message here.


Image Verification
Please enter the text contained within the image into the text box below it. This process is used to prevent automated spam bots.
Image Verification
(case insensitive)

Possibly Related Threads...
Thread Author Replies Views Last Post
  pwm rectifier ppt jaseelati 0 98 21-01-2015, 01:57 PM
Last Post: jaseelati
  deadlock detection algorithm source code c jaseelati 0 287 10-01-2015, 02:18 PM
Last Post: jaseelati
  pwm rectifier ppt jaseelati 0 98 09-01-2015, 01:50 PM
Last Post: jaseelati
  matlab code for mppt algorithm jaseelati 0 227 16-12-2014, 02:37 PM
Last Post: jaseelati
  Overview of 3GPP LTE-Advanced Carrier Aggregation for 4G Wireless Communications pdf project girl 0 450 07-02-2013, 03:42 PM
Last Post: project girl
  IMPLEMENTATION OF ALGORITHM FOR DIAGNOSIS OF ECG WAVEFORM USING MATLAB. seminar class 8 4,901 07-02-2013, 11:23 AM
Last Post: Rahul28047
  Genetic Algorithm Optimization for Circular Microstrip Antenna pdf project girl 0 417 24-01-2013, 01:00 PM
Last Post: project girl
  Half-bridge and full-bridge converters seminar tips 0 358 18-01-2013, 03:02 PM
Last Post: seminar tips
  A Genetic Algorithm Based Economic Load Dispatch Solution for Eastern Region of EGAT seminar tips 0 19,756 18-01-2013, 02:59 PM
Last Post: seminar tips
  2A Dual Motor driver module with PWM control [RKI-1172] project girl 0 359 20-12-2012, 03:20 PM
Last Post: project girl